Home › Washer › Fix

Washer Leaking Water? Find the Leak and Fix It (Utah)

Last checked: October 25, 2026

Likely causes

• Loose, cracked or bulging fill hoses
• Torn or dirty door boot seal on a front-loader
• Loose drain hose or clogged standpipe overflowing
• Too much detergent, or regular detergent in an HE washer, causing suds to overflow
• Cracked drain pump or pump filter not tightened
• Leaking water inlet valve

Safe DIY checks

Safety first: unplug the appliance or switch off its breaker before touching anything inside, and shut off the water or gas supply where it applies. If you smell gas, leave the house and call your gas utility from outside.

1. Turn off the water valves behind the washer if the floor is wet and you cannot find the source.
2. Check the fill hoses at both ends and replace cracked or bulging rubber hoses.
3. On a front-loader, check the door boot for tears and gunk, and wipe it out.
4. Make sure the pump filter cap is tight after cleaning.
5. Use HE detergent in HE washers, and only the recommended amount.
6. Run a short cycle with an empty drum and watch where water appears.

When to call a pro

• Water comes from under the washer, not the hoses
• The door boot is torn
• The tub or pump is cracked
• Water has reached flooring, a ceiling below, or drywall

Typical repair cost in Utah

Call for a quote. Costs depend on the brand, the part and the shop, so ask for a written quote after diagnosis. Most Utah shops charge a diagnostic or trip fee, and many credit it toward the repair.

Repair or replace?

Hoses and door boots are usually worth replacing. A cracked outer tub on an older washer is a bigger job and often a reason to replace. Read the repair or replace guide.

Still stuck? These Utah shops service washers:

Utah shops that can help

FAQ

Last updated: October 29, 2026